54Rich
Member
- Joined
- Apr 10, 2007
- Messages
- 675
Well, here I'm again Anyhow, wish I was looking for speed parts, but no.
I'm replacing the dash and was about to put the manual control back in, when I notice that the vacuum switch looks loose. Now I don't know if I broke it sliding it through the dash or it's been that way.
It's the switch that all the vacuum lines go to on the control unit. When you move the control lever it turns the switch. It's round and is connected to the control unit with one 1/4" screw. It looked like the center screw fell out of it, however, it dosn't hold a screw, must have been a plastic pin holding it together.
Anyone have one laying around?
Thanks,
Rich
I'm replacing the dash and was about to put the manual control back in, when I notice that the vacuum switch looks loose. Now I don't know if I broke it sliding it through the dash or it's been that way.
It's the switch that all the vacuum lines go to on the control unit. When you move the control lever it turns the switch. It's round and is connected to the control unit with one 1/4" screw. It looked like the center screw fell out of it, however, it dosn't hold a screw, must have been a plastic pin holding it together.
Anyone have one laying around?
Thanks,
Rich