melted coil while key on engine off position.

[cutt]

what would cause this? replaced module and coil, now no fire?

 

[turbo nasty]

Check fuses

 

[cutt]

checked them. all good. and i have power at the pink wire going to ignition module

 

[turbo nasty]

No fire meaning the engine doesn't fire off or no fire meaning you have no spark?

 

[cutt]

no spark

 

[No disintegrations]

What melted? The inside of the module?

 

[cutt]

to the point that is was oozing out,

 

[TurboBob]

some of the aftermarket replacement modules are much less tolerant of the CAM sensor timing. I would re-time the cam sensor by hand and try again.

 

[cutt]

turbobob, why would it get that hot with the key on engine off?

 

[TurboBob]

it shouldn't, I think your original module failed, and melted itself down.

 

[cutt]

ignition module failure would cause the coil pack to meltdown?

 

[ScottHeidinger]

Did you open the coil pack/module? The epoxy inside may have melted with heat causing a short


Sent from my iPhone using Tapatalk

 

[cutt]

yes. it melted. i replaced them but now i have no spark.

 

[ScottHeidinger]

Ccc1 fuse is good?


Sent from my iPhone using Tapatalk

 

[ScottHeidinger]

SES light is on When you’re trying to start it?


Sent from my iPhone using Tapatalk

 

[626gn]

ignition module failure would cause the coil pack to meltdown?

Yes. It's possible a bad module can take out a coil pack.

 

[cutt]

SES light is on When you’re trying to start it?


Sent from my iPhone using Tapatalk

having this problem again. the ses light is not on but i have a fast grey box so i dont remember if its still operates