This intake, as far as I know, is a one of one unit made by Bowling Green Customs for Drew Carlton back in the late 90's to early 2000. The intake has been cut open on the bottom with work performed on the dividing wall inside the intake. The injectors have been unshrouded and there was minimum runner work performed.
My dad and I made an egr block off plate and blocked off where the egr pipe enters the intake as well. This can be undone if someone wants to use the egr.
It comes with the thermostat neck and a good 160 degree tstat installed.
Drew ran 12.20s without alky with this intake and I have run 12.70s.
I switched to an 86/7 intake setup or this would still be on my car.
I am asking $150 + shipping.
Please respond to this thread so I can keep everyone in line where they're supposed to be.
I do accept paypal.
Jerry jr.
My dad and I made an egr block off plate and blocked off where the egr pipe enters the intake as well. This can be undone if someone wants to use the egr.
It comes with the thermostat neck and a good 160 degree tstat installed.
Drew ran 12.20s without alky with this intake and I have run 12.70s.
I switched to an 86/7 intake setup or this would still be on my car.
I am asking $150 + shipping.
Please respond to this thread so I can keep everyone in line where they're supposed to be.
I do accept paypal.
Jerry jr.