Well about 3 weeks ago i went out to arizona and put a few new parts on the car. i installed pauls, hr bar, double adjustable uppers, +1/4 lowers. i also installed qa1's, factory replacement springs for the rear, and pauls tranny crossmember mounts. i have other parts i need to put on but not sure if i will get them on before the WCN. also i need to adjust the pinion angle as its at -4 at the momment. anyways pictures speak for them selves. everyone likes pictures.
o a few things on the picturs. i was installing the hr bar with no directions as i had it sitting in a box for years so the bolts are wrong on one side while its dangaling there. and also the new directions say put a washer between the gold bushing holder and the black axle clamp which i will do when i go out next. i didnt get any picture of the cross member bushings.
rear end is fully built. welded axle tubes, 33 spline axles, spool etc, im going to be ordering all wheel disk and front sc&c parts but havent done it as i dont have time to put it on. anyways let me know what you think
o a few things on the picturs. i was installing the hr bar with no directions as i had it sitting in a box for years so the bolts are wrong on one side while its dangaling there. and also the new directions say put a washer between the gold bushing holder and the black axle clamp which i will do when i go out next. i didnt get any picture of the cross member bushings.
rear end is fully built. welded axle tubes, 33 spline axles, spool etc, im going to be ordering all wheel disk and front sc&c parts but havent done it as i dont have time to put it on. anyways let me know what you think