My scanmaster readings

[Junior Samples]

02. 740 to 760
AF. 06 to 07
L8. 54 (at idle)
bat is fine
int. 120 to 132
bL. 115
stat was at 170, dunno whats in it but im gonna put 160
outside 84
rpm 800
tps .42 good there eh?
iac is at 50?
cc went to 230 then back to zero
no pl or sp reading
_________________________________________

My vacuum is steady at 14 inches..errrrrr chased down every hose and sprayed every gasket with no change
Mild poston #107 cam

Have that damn miss that could very well be my #4 injector but no fer certain.

my cat tripped me up this morning and i hit my head falling down the stairs.

And everytime I see a bum walking down the street i say...he was once a damn good laquer man.

insight on readings anyone?

Mike C

 

[Junior Samples]

addition

stat is 195 id guess but fan came on at 206.

thats next to go

 

[ES1]

IAC is too high set 10-20
Will need to reset TPS after IAC is corrected.
BLM show a little on the rich side.
Check where they are while driving,
Check MAF & O2 numbers @ WOT and report.
Whose chip?

 

[johnnyttype]

were these reading taken in park or drive? the IAC should be anywhere from 10 to 30 in park, but if in drive it will climb to alittle above 50!

 

[Junior Samples]

re:

readings were takin in park, should i get on freeway about 70 and get readings again?

Also should I put stock chip back in and get my readings first? dunno whose chip it is, nothing on it to denote who burnt it.

once again the motor is 30 over with poston #107 cam (mild) stock turbo and green stripe, of course all this will change this winter...muhaahaha

Mike

 

[Junior Samples]

addition

ok WOT and report... i can do that

 

[johnnyttype]

is there any markings on the outside of the chip, i think i had a poston chip before and it had a turbo six logo. to figure out what it is u may have to take the chip out and look at the where there should be a label of some sort.