need pistons 4 6inch rods

[meanmachine]

i'm installing a 3.400 eagle crank and 6" rods in a 109 block and need a set of pistons with a 40 thousand difference in compression height and would like to know what brand others have used with this combination. also would like to know what vendor and round about cost of the pistons.

thanks ,danny

 

[9SECVSIX]

The 3.8 -109 pistons I used with a 6" K1 Rod were Diamond, 1.810 CH and a 927" pin. I got them from Fullthrottle....there a custom piston and will have to be special ordered unless Dan at DLS has them on the shelf...that's a long shop IMO.

 

[Mike Licht]

What size wristpins do you have? what size bore? I may have a set here
Mike

 

[meanmachine]

mike, i'm looking for a set of .020 over with a .927 pin.