New face for JayC's ProPain controller

[S10xGN]

Hi All,

I just printed and installed a new faceplate sticker for my ProPain controller. I had originally made 3 individual "dials" with markings for boost on my HP deskjet but they had faded, and since I had a vinyl printer, went for it! These boost markings are calibrated for my own specific controller, but are prolly close enough for others. I scraped my original sticker off while removing my homemade dials but this would look better installed over top of the original.

Sorry, was gonna post an image, but that option has disappeared??? So here (and there WILL be popups!):

 

[S10xGN]

Sorry, forkin' freeware site doesn't allow linking. Try here

 

[1badTTA]

(crosslinked from T6P)

My controller setup (more of a transplant than a facelift)