Ok guys I got a quick HG question

[DailyDrifter]

I know this is the wrong forum , but theres over 300+ people in here right now

I have the heads on right now. I started at 50lbs, then 60, then 70lbs for the final torque. I have Cometics that have the rivets drilled out, I put copper spary in between each layer . Also have ARP BOLTS. Is 70lbs good to end it with or should I go to 75lbs? Thanks in advance guys.

 

[Lee Thompson]

Imo

I go 75 for the bottom row and 80 for the top row--top row being longer---right or wrong--that is what I do--studs or bolts- --same torque values. Best of luck.

 

[DailyDrifter]

Thanks for the advice, I just got done going to 75lbs on all of them. I'll re-torque it again tomorrow.