One off parts. Lets see some pics.

[boostingbuick]

Here is my breather tank. Its bolted to the three mounts behind the washer bottle. Plus I made push in breathers with an AN fitting on it, with uses braided line to the tank. That way the valve covers would not be modified.

 

[gbodygmachine]

First pic is the gauge cluster

This is the corvette C5 Brake setup. Custom made everything

This is the coilover crossmember setup

 

[boostingbuick]

This a bad photo but its the exhaust hanger I made to support the muffler. I just ran a longer seat belt bolt and used a spacer with a nut.

 

[NASSTY]

This is my one off rear end cover.Kirban sold a similar r/e cover back in the early 90's.That's where I got the idea from.It was kind of dirty when I took the picture. :redface: However, it didn't take much skill to make like most of the other one off parts in this thread.

 

[boostingbuick]

Skill is not the point here, pride is. And anyone who will post a pic of their stuff takes pride in that. So good for you in doing it yourself. Plus I'd rather see some almost perfect parts than paying someone to do it for you.

 

[turbofabricator]

Am I still banned??:biggrin: If not, here's the 4" MAF for a TTA, the oval intercooler pipes, IAC angle adaptor, fuel regulator replacement fitting.

 

[boostingbuick]

Show off. Looking good. I had to say that so I could get half a chance here.

 

[boostingbuick]

This is for the wire from the battery to the alt. that runs under the engine. I have a girdle so the factory bracket will not work. So I made this one to hold the wire out of the way.

 

[boostingbuick]

Maybe I should post the pics?!!!

 

[hounddogs!]

Nobody will ever see it, but...

I was appalled at some of the wiring on my car when I got it. (Exhibit A, power to the oil pressure gauge went thru a switch in the ashtray. Several 'Oh $hit' startups before I remembered to turn on my gauge)

I've run Bat hot, accy hot, ground and an IP light feed to this central wiring block, then out to 4 gauges, the radio and the line lock. The GM fuse block looks much cleaner.

This is Velcro'd to the back of the glove box, so it's not something to show off at the local meets.