pcv rubber seal help?

[87Turbolimited]

Hey fellas need your help so I was replacing my pcv with the rjc one so while removing the rubber seal it was dry an stear off a bit so while holding it with a screw driver in feld inside the intake at this point i was so MAD an piss off!! would there be any issues if I left it in there I know this is a '' dumb questions'' or ill just have to remove the my intake to pull it out... thanks

 

[turbo nasty]

LOL very common no issues at all.

Tip on reinstalling new one is to place the grommet in hot water before installing and that will make it more pliable/flexible. Kirban has the correct one pretty sure the parts store help section ones arent quite right as ours are a lil odd sized.

 

[87Turbolimited]

LOL very common no issues at all.

Tip on reinstalling new one is to place the grommet in hot water before installing and that will make it more pliable/flexible. Kirban has the correct one pretty sure the parts store help section ones arent quite right as ours are a lil odd sized.

cool thxs for your reply an help, ill look into kirban today see if i can buy the right rubber seal... an besides the rubber peace that feld in there everything would be the same no issues at all...