Hey everyone,
Im upgrading a few parts on my car so Im getting rid of what I dont need. Pics are available and can email them as requested.
1. TE63 turbo - no in/out shaft play, slight side to side play, fins look good and are not hitting the housings. Doesnt burn oil and has .63 A/R exhaust housing. Spools great with a 2800-3000 stall. Has a couple spots on the intake flange of the compressor housing where it had been nicked and smoothed out. Run it just fine as is. $400/shipped
2. MSD 50 Lb/hr injectors with street chip - Low miles (less than 5k), high impedance (uses stock ECM), engine ran great with them. Pretty sure the chip is a Reds 93 octane chip. $225/shipped
3. Hooker 2.5" downpipe w/deltagate included. - The downpipe has been cut halfway down and was using it as a fender dump. Gate works fine. $120/shipped
4. MAF sensor - used stock, works fine $75/shipped
Trades? Im looking for an angle IAC block and deep aluminum trans pan. May entertain a set of ported iron heads ready to go.
I have other performance/stock items listed here too.
http://www.turbobuick.com/forums/parts-sale/340335-ecm-max-effort-r-chips-injectors-bezels-etc.html
And I have driver and passenger fenders for a GN $100/each + shipping
pics here:
http://www.turbobuick.com/forums/parts-sale/339044-look-86-gn-interior-body-parts-sale.html
Ill probably have more things to sell as I come across them.
Im upgrading a few parts on my car so Im getting rid of what I dont need. Pics are available and can email them as requested.
1. TE63 turbo - no in/out shaft play, slight side to side play, fins look good and are not hitting the housings. Doesnt burn oil and has .63 A/R exhaust housing. Spools great with a 2800-3000 stall. Has a couple spots on the intake flange of the compressor housing where it had been nicked and smoothed out. Run it just fine as is. $400/shipped
2. MSD 50 Lb/hr injectors with street chip - Low miles (less than 5k), high impedance (uses stock ECM), engine ran great with them. Pretty sure the chip is a Reds 93 octane chip. $225/shipped
3. Hooker 2.5" downpipe w/deltagate included. - The downpipe has been cut halfway down and was using it as a fender dump. Gate works fine. $120/shipped
4. MAF sensor - used stock, works fine $75/shipped
Trades? Im looking for an angle IAC block and deep aluminum trans pan. May entertain a set of ported iron heads ready to go.
I have other performance/stock items listed here too.
http://www.turbobuick.com/forums/parts-sale/340335-ecm-max-effort-r-chips-injectors-bezels-etc.html
And I have driver and passenger fenders for a GN $100/each + shipping
pics here:
http://www.turbobuick.com/forums/parts-sale/339044-look-86-gn-interior-body-parts-sale.html
Ill probably have more things to sell as I come across them.
), TTT!!
