Piston to deck dimension

[Jerryl]

What is the piston to deck dimension on a 14 bolt block? (Stock rod/piston)
The block will need to be shaved and trying to see if this 11 year old block can be saved.
Unable to find info . . . .

Yes, this was before I could spell boost, detonation, fuel pressure, scanmaster or anything else for that matter . . . .LMAO!

 

[bison]

You're not saving that one without welding. Not
worth it

 

[Jerryl]

You're not saving that one without welding. Not
worth it

Ok . . . my buddy is using it for a table in his garage . . . or . . . it's going to scrap.

 

[charlief1]

Send me a note if you need another one Jerryl. I've got 2 standard 14 bolt blocks and 1 standard 85 20 bolt block sitting around.

 

[TurboBuRick]

Damn....

 

[Jerryl]

Send me a note if you need another one Jerryl. I've got 2 standard 14 bolt blocks and 1 standard 85 20 bolt block sitting around.

I have one other block that is std. bore and good.
If I only had the access to the equipment to cut the oil pan rails off . . . .

Damn....

LOL . . . Damn is right . . .. . but the Porsche lost. LOL . . . Oh the memories.


BTW . . . . If anyone thinks it takes a lot of HP to do this . . . I can assure you it does not!
This was a stock HA so probably 25-30 HP/ hole.
I decides to post this picture because there is still some believe that you do not need a scantool and a way to monitor KR, or keep pushing when you see KR . . . . or . . . LOL!!!

 

[dr_frankenstein]

I have one other block that is std. bore and good.
If I only had the access to the equipment to cut the oil pan rails off . . . .

im not sure i understand.... but I could help ya out with this?