You can type here any text you want

power looger/lc1 innovat wide band

Welcome!

By registering with us, you'll be able to discuss, share and private message with other members of our community.

SignUp Now!

tta1240

CAMEL TOE
Joined
May 5, 2003
Messages
510
i am installing a new engine harness in my gn and need to know how to connect my wideband 02 (lc1)to the power logger. on the wide band it has
a red,blue,black,brown,yellow,white,, wires.the power logger cable has
1 2 3 4 5 6 7 what wires go to that connection so the power logger can get the wideband readings to try and maintain proper a/f ratio? also my car has digital dash,what wire on the ecm harness do i run for the map signal?

i hate to ask all thease ??? but i have no direction for any of them.
thanks jim.
 
brown wire of LC1 which is output 2 goes to the logger block input #1


digital dash doesnt have or support a map sensor so how do you plan to tap a map sensor you dont have

if you have a map sensor the pl block has a 5v and a grnd to run the map and the map output goes to the #2 input , or you could read how to wire a 3bar map with digital dash thread in the alky forum
 
I'll just drop by and do it for you if you pay for gas !!!

not at thease prices :D

i already have a 3 bar map sensor in the car for the alky i think i need to run the green wire to the P/L also.all this stuff was in my car when i got it,i thought i had problems with the trans pro so i decided to ditch it and unhooked everthing.i now am going to be running a Turbo Tweak sd chip and need to wire in the wide band and map sensor.i would have kept the trans pro if i would have known the hack job done to my engine harness that was actually was causing all of the problems. i cant believe the money i spent to get this car wired correctly from another board member. After i peeled back the conduit i found all kinds of poor connections. For example....on the 3 main power wires for the engine harness it had a butt connector onto a half inch piece of wire onto another butt connector and another piece of short wire and another butt connector. All 3 of these wires were tightly taped together and were arching under the tape. I decided to cut my loses and put in a new harness in my engine compartment. I need to know how to hook up the wide band and the map sensor. Thanks for all the advice, greatly appreciated.
 
Back
Top