removing speedo Bullet to change gear

[gbsean]

I have heated it....soaked it....pryed it and it wont come out....need to change the speedo gear as I have moved up to 28" tires and want speedo to read right for convetor lock and power logger etc...

 

[SNOWBIRD]

if you remove trans pan and governor you will be able to use a long punch to drive it out ,but you will probably damage or bend speedo gear

 

[A2000RICH]

I have heated it....soaked it....pryed it and it wont come out....need to change the speedo gear as I have moved up to 28" tires and want speedo to read right for convetor lock and power logger etc...

if you can't get it out i have a special tool that pops it right out easily with no problem no matter how tight or rusted it is with no damage------give me a call and perhaps i can loan it to you for a day via UPS...........RC

 

[gbsean]

well I cannot get it out....Richard I sent you a PM

 

[Darrell1987SS]

I had a tough time removing one too. In the end I was able to start rotating it with a pair of vise-grips, which worked it loose and let more pentrant in, but it did some damage to the speedo cable threads. If I had the end of an old speedo cable to thread on first I probably wouldn't have done any damage.

 

[gbsean]

Richard is sending me his tool....and i also ordered a new bullet....

 

[Darrell1987SS]

Could you tell me where and how much for the speedo housing?

I think the P/N is 54774, but couldn't find it at bulkpart.

 

[SSedan64]

Bulkpart doesn't carry gears so they probably don't have the housings either. Here's one>>
www.CKPerformance.com

 

[Lee Thompson]

The way I get them out

Vice grips--bees wax and a propane torch--be prepared to replace the bullet.

 

[gbsean]

Could you tell me where and how much for the speedo housing?

I think the P/N is 54774, but couldn't find it at bulkpart.

from here about 1/2 way down page in 200r4 section $19.00 plus shipping ordered new gear 2 weeks ago and got it in about 3 days

Speedometer Gear, Speedometer Gears, Ford, GM, Dodge 700R4