I've disassembled the stock, iron disc brake front calipers to rebuild & detail them.
What will be the most practical way to re-install the rubber boot, that fits around the piston?
The only "seal installing" tools I can locate in this size (about 3" diameter), generally only come in expensive sets (eg Snap-On or Matco). And , the rubber boots are about $10 each, can't risk too much trial & error experimentation.
TIA.
(my rotors now look 'purdy, used POR15 grey primer with the POR MetalMask natural cast iron topcoat).
What will be the most practical way to re-install the rubber boot, that fits around the piston?
The only "seal installing" tools I can locate in this size (about 3" diameter), generally only come in expensive sets (eg Snap-On or Matco). And , the rubber boots are about $10 each, can't risk too much trial & error experimentation.
TIA.
(my rotors now look 'purdy, used POR15 grey primer with the POR MetalMask natural cast iron topcoat).