hello; I finally got the brace installed with the mod Dsapper had done with his because of the PTE SLIC. In my case one tube had to be dippled a bit and you know what that meant. A big hammer as the tubing wall thickness is like .125. It's not the best way to do it but that's what the pocketbook said to do.
The brace is alot beefier than any other braces I've seen. We put the cross over pc. with like a .250 gap to the IC as I didn't want it too close. The design has that cross over pc. about midway and that's the best place for it but the mode is the only way it will work with the PTE....................
It did stiffen things up and I kept that other sq. stock brace that Kirban sells.
IBBY
The brace is alot beefier than any other braces I've seen. We put the cross over pc. with like a .250 gap to the IC as I didn't want it too close. The design has that cross over pc. about midway and that's the best place for it but the mode is the only way it will work with the PTE....................
It did stiffen things up and I kept that other sq. stock brace that Kirban sells.
IBBY