About a year ago I had an Innovate LC-2 wideband O2 sensor and kit and a Powerlogger installed. I also got an upgraded T/T Powerlogger chip to match the mods. (Change was also made to Scanmaster)
I had it all installed by our local Turbo Buick guru (he has someone do his elect work). I know you have to calibrate the wideband initially but the car never had any settings changed to the chip after that.
The car isn't driven much and about 6 months ago I had a battery go dead and put in a new one. I have just been driving it occasionally with no hard runs other than a quick romp away from a light now and then.
My question is ---- I know if changes had been made to the chip they would have been lost after losing electrical power when I changed the battery. But nothing was changed after the initial install. So do I need to reset anything or is it ready to run?
Thanks
I had it all installed by our local Turbo Buick guru (he has someone do his elect work). I know you have to calibrate the wideband initially but the car never had any settings changed to the chip after that.
The car isn't driven much and about 6 months ago I had a battery go dead and put in a new one. I have just been driving it occasionally with no hard runs other than a quick romp away from a light now and then.
My question is ---- I know if changes had been made to the chip they would have been lost after losing electrical power when I changed the battery. But nothing was changed after the initial install. So do I need to reset anything or is it ready to run?
Thanks