Studs for the turbo-downpipe connection

[Boston GN]

Anyone know off hand if someone makes a "kit"
Maybe ARP? If there isn't, does anyone know the size off hand I would need. It would make lining up my DP for install super easy.
If this is a stupid idea or no one has done this, does anyone know where to get some decent DP bolts to use in this situation. I have some older ones but I don't trust them.
TIA

 

[HYBRIDT]

I did that and it does make it really easy to line up the flange. I'll take a look at my notes and find out the size for you. I just bought bolts that were the right length and cut the head off, cleaned up the end and threaded it into the turbo so the factory end was facing out. I also put studs on the drain flange. Someone ought to put together a kit for turbo studs.

Adam

 

[Boston GN]

Thanks Adam, I'd appreciate it!!
I definitely think someone should put a little kit together. I bet it'd sell pretty well.