Tranny cooler question

[excobraguy]

I'm getting ready to mount my tranny cooler. Is it OK to mount the cooler with both lines horizontal to each other or does the return line have to be lower that the feed line for proper fluid flow????? Thanks for the input....Dean

 

[excobraguy]

Anyone???????????

 

[Chrisk]

shouldnt matter since the fluid is pumped thru the cooler.

 

[Roc87]

My B&M said to have the return higher than the inlet, to keep air bubbles to a minimum.

Doubt it really makes a difference

 

[excobraguy]

shouldnt matter since the fluid is pumped thru the cooler.

Hey, this is exactly where I'm mounting mine!!!! How does yours cool from here????

 

[Roc87]

Hey, this is exactly where I'm mounting mine!!!! How does yours cool from here????

That's where I have mine also, it has a built in fan, that very rarely comes on, so it must cool pretty good.

 

[V6POWER]

roc87--Where did you get your cooler with fan?

 

[Roc87]

From Summit, I think it was around $200. Has built in fan & thermostat. Instructions wanted inlet on the same side as the thermostat, thermostat is bottom left of pic, and inlet is bottom right. Outlet is behind bumper in the pic. Pic makes it look like this thing hangs down lower than it really does.

 

[V6POWER]

Thanks.

I have a stock location, stretch IC so I don't think I can mount the fan where you have it mounted. It would block the air coming into the IC.

 

[BARTGN]

Trans Cooler

I talked with tech rep. from B&M ,said to mount with in & out on top, Air does not cool. (paraphrase). Second best is in on bottom out on top.You get the picture.