Trans cooler fitting

[bigballsbilly]

I have a f body radiator, and the original fittings in the end if the teams cooler lines were the correct size. I now want to convert to braided lines and an fittings. I did a search and I didn't quite find the answer I was looking for.

Question is, is this the fitting I need at the radiator?

https://m.summitracing.com/parts/aer-fbm2964

Thank you

 

[psycho6cyl]

Out of the radiator is 1/8 npt. I'm pretty sure.

 

[bigballsbilly]

I though i read on another thread it's a #5 flared. Which I'm thinking is a 5/16?

 

[Angermgt]

The stock fittings are 5/16 inverted flare. I had a hard time finding those fittings. Ended up ordering from Goodman products

Sent from my SM-G935V using Tapatalk

 

[Heskahoka]

The stock fittings are 5/16 inverted flare. I had a hard time finding those fittings. Ended up ordering from Goodman products

Sent from my SM-G935V using Tapatalk

Can confirm. Just did this job plumbing the tranny into my radiator and external cooler. I have a GN1 radiator, but the fittings/fitment should be the same.
90 degree fitting on the radiator:
-The male end going into the radiator is 1/8 NPT.
-The female end to the transmission line is 5/16 Inverted flare.

This is a tough combo to adapt AN to.

You might be able to remove the fittings into the radiator, then use a 1/8 NPT to 06AN 90 degree adapter to go straight from your flex line into the radiator:

It's always an engineering challenge with the fittings on these cars!

 

[bigballsbilly]

Ok thanks, I ordered the parts. Fingers crossed.