Tubular Rear Lower Control Arms

[RBE17]

I have a used set of tubular rear lower control arms that have been freshly powder coated black. They are carbon steel and double adjustable w/ rod ends. They are also from a fourth gen f-body so they will fit a TTA. I am not sure if they'll fit a g-body. If someone knows the stock length of a g-body rear LCA I'll be able to tell if these will fit. I'd like $115 shipped to the lower 48 for these.

Thanks,


Steve.

 

[SSedan64]

Most say 19-1/4" C to C.
From a member on another site:
About the LCA length: I measured two stock LCA's, on both sides of the LCA's. The average of four measurements is 19.31" +/- 0.020".

 

[49-blues]

Any pics?

 

[RBE17]

Most say 19-1/4" C to C.
From a member on another site:
About the LCA length: I measured two stock LCA's, on both sides of the LCA's. The average of four measurements is 19.31" +/- 0.020".

Thanks. I'm thinking these might be a little too short for a G-body. I'll have to measure to verify.

Any pics?

I'll try to get some tonight.

 

[RBE17]

Here are some pix. Actually, length wise these will fit a g-body. The measurement picture is w/ the start end at zero. It represents end to end not center to center.

 

[RBE17]

All PMs replied to.

 

[RBE17]

Price decreased to $95.00.

 

[RBE17]

Sold.