larrym
West Coast Newfy
- Joined
- Jul 17, 2007
so i was installing my new 2 step and I'm having trouble, key on both leds flash green, fire it up and the main is flashing and its working at idle sputtering away. Set all the main rpm switches on still nothing. same with the trig rpms no change. Shut it down and flipped the confg 1 switch off fire it up it runs but it throws a code 42.
Unplug the rpm signal from the 2 step fire it up codes gone runs well.
Reversed the rpm signal wire ran like it was unplugged no limiter function, messed with it for a couple hours double checked all my connections. I even disconnected my wire tap for the Gen2 no change same white b4 wire.
While it was running the trigger led would light up once in a while.
Unplug the rpm signal from the 2 step fire it up codes gone runs well.
Reversed the rpm signal wire ran like it was unplugged no limiter function, messed with it for a couple hours double checked all my connections. I even disconnected my wire tap for the Gen2 no change same white b4 wire.
While it was running the trigger led would light up once in a while.