Turbo Specials

[HighPSI]

Due to overwhelming response of our last BallBearing Turbo Special, we are going to offer another special on the GTQ Ball Bearing turbos. These Turbos are priced too LOW to Advertise and will be good thru the Bowling Green Event.

Call Hartline Performance @ 321-722-1563 for Pricing.

 

[John Wilde]

Due to overwhelming response of our last BallBearing Turbo Special, we are going to offer another special on the GTQ Ball Bearing turbos. These Turbos are priced too LOW to Advertise and will be good thru the Bowling Green Event.

Call Hartline Performance @ 321-722-1563 for Pricing.

What is the Biggest BB you can run with a stock D5.
Remember a little lag is ghetto traction/boost control.

 

[HighPSI]

sent you a PM

 

[Otto J]

Cal, PM sent

 

[xXch0dyXx]

awww boooooooooo, i just bought a turbo 4 days ago because there were no good deals on BB going on

 

[87natl]

Cal,

Can I get away with 3000 stall on my new stroker motor for that 67BB? If not, what'cha got for a turbo/converter combo to sell me??? ;

No need to ship it, I'll just come pick it up.

 

[HighPSI]

I would normally say no. Depends on if you want what John refers to as "ghetto traction control". Did you get the "P" trim or the "Q" trim from us? Camshaft, compression, tuneup, etc.. are all factors that can effect spoolup.

 

[87natl]

You misunderstand me. I have a 3000 stall right now. I want a turbo to put on this stroker motor being built. I don't think the TE-60 is gonna cut it for me any more. So I am potentially looking for a turbo AND matching converter. The turbo for sure. Sorry for being unclear.

 

[Otto J]

With a stroker and real 3000 stall (not a 12") i bet it would be good

 

[87natl]

I was figuring the extra cubes might make it doable. But I don't know if there is enough strokers out there yet for a good case study. Hey, that's what guinea pigs are for.

 

[turbocody]

the more motor you have the less stall is going to be needed. what is it they say "there is no replacement for displacement!"

 

[cruzn57]

what size? and trim?

250 cu in, 232@50 solid roller, M&A ported heads ,champ intake, 3600 stall, 8.5 to 1, 95lb inj, I'm thinking 70, but hear 76 or? want good spool up,
3 bolt, or 4 bolt? (will be getting new exhaust) and using the fast system you sold me!!!
Thanks