fastblackracing
Well-Known Member
- Joined
- Apr 7, 2009
Will the replacement billet yokes stop the spline twisting ? Which one is best? Thanks.
What is the best aftermarket trans yoke?
- Thread starter fastblackracing
- Start date
- Joined
- May 28, 2001
I used the Mark Williams yoke and rear flange. NP's.
TexasT
Texas, Where are you from
- Joined
- Sep 10, 2002
http://www.dennysdriveshaft.com/p13..._inch_3r_series_fits_all_700r_and_4l60_t.html
Not sure if it is "the best" but I have ordered u joints and such from dennys. I can see why they would sell an inferior slip yoke. As far as twisting the splines on an out put you must have a FIERCE launch.
Not sure if it is "the best" but I have ordered u joints and such from dennys. I can see why they would sell an inferior slip yoke. As far as twisting the splines on an out put you must have a FIERCE launch.
fastblackracing
Well-Known Member
- Joined
- Apr 7, 2009
The twisted splines are in the output yoke itself. Makes getting the driveshaft out a real PITA. And yes mid 1.3x short times. Been through several stock driveshafts over the years and I'm tired of dealing with it. Just want to make sure I spend my money on the right stuff before buying a 500$ shaft. Thanks for the input guys. .
