Where to tie boost gauge in

[NorEaster]

Vac/Boost gauge should be arriving today. Where is the spot to tie it in so I wont loose the use of the LED?

 

[justin84]

Vac/Boost gauge should be arriving today. Where is the spot to tie it in so I wont loose the use of the LED?

Tie into the MAP sensor vacuum line with a three-way "t". This is the same line that works the LED's. I have always used that spot on all my cars and customers cars as well.

 

[Razor]

I "T" into the line going to the charcoal cannister behind the alternator.

 

[jasjamz]

I "T" into the line going to the charcoal cannister behind the alternator.

The same way I've been doing it for years. My friends do it this way also.

 

[Scott87]

Only problem I see tieing into the charcoal canister is if the check valve before the canister is flaky.

 

[BlackBandit]

I tee'd into the FP reglator line. That way I get manifold pressure and I will immediately know if I have a problem with the reference to the regulator. I know it adds a posible leak or failure point. I just make sure all the connections are up to that task.