I have been receiving a bunch of calls about how to rewire the Scanmaster & eDash to use the new com port that is available with the 2.05 software upgrade. You will need 3 XFI pins, 2 small and one large. Once you have these, cut the plug off the eDash/Scanmaster cable.
Put a small pin on the red wire and insert into XFI cavity C30 (Blue plug)
Put a small pin on the white wire and insert into XFI cavity C31 (Blue plug)
Put a large pin on the black wire and insert into XFI cavity D12 (Smallest Grey Plug)
To insert a wire into an XFI plug, you will need to push the white release tab out. It will only extend about 1/16". One you have inserted the pins, be sure to relock the white tab.
If you purchased the eDash/Scanmaster from us and would prefer to have me repin it, I will do it free of charge.
Put a small pin on the red wire and insert into XFI cavity C30 (Blue plug)
Put a small pin on the white wire and insert into XFI cavity C31 (Blue plug)
Put a large pin on the black wire and insert into XFI cavity D12 (Smallest Grey Plug)
To insert a wire into an XFI plug, you will need to push the white release tab out. It will only extend about 1/16". One you have inserted the pins, be sure to relock the white tab.
If you purchased the eDash/Scanmaster from us and would prefer to have me repin it, I will do it free of charge.