Recent content by FlightTest

Thank you very much for the input Mike. I bought the set of heads from you a long, long time ago. Does T&D still make the shaft mounted setup?

Thanks for the responses, I am going to try a couple different ratios for fun. I would love to find a shaft roller setup but the ones I have seen are big bucks. I have heard TA sells the valve cover gaskets and I should get a new set the next time I have the valve covers off because the stock...

Do you think they are a small block chevy rocker or maybe a pontiac?

Does anyone out there with the old aluminum M&A cylinder heads remember what stud mounted roller rockers they use. I want to play with some different rocker ratios. If memory serves they were regular crane 1.65 ratio small block chevy rocker arms but I am not sure. Anybody have a part number...

Are those for M&A Heads?

In once again, I couldn't sleep last night thinking about this cool project!! I can't wait to take it to the track and show all those stangs my new tail lights!! Just dreaming!

Does anyone sell the 1.5 inch Wastegate pucks for the Terry Houston downpipes? I see RJC has 1.375" but I am trying to find the 1.5 inch. I heard Mease had them but can not find them anywhere. Thanks!!

What a great idea!! Hats off to you and your sponsors!! Semper Fi!

Hybrid 85. Now that name is a blast from the past. Where did you know him from? Marrietta or Edwards?

I have almost 120,000 miles on mine. Eons ago when I first bought them they had some casting porisity in the number 2 intake port that had to be repaired. Mike Licht repaired them no questions asked and they have worked well since then. My only real complaint is the valve cover gaskets grow...

I have had five gallons of Methenol in the shop for about five years now, and use it in my Buick on rare occasions. Does this stuff go bad? "Z"

Awesome!!! I am in!!!

You can use bolts when you replace the motor but it is way esier to just get some 1/4 rivets and rivet them in again. It is a real pain to get to the back of some of the bolts. I did have a hard time finding big 1/4 inch rivets, but finaly found them at NAPA. The go in super easy.

Like Fulie600 said you have to input the correct tire height, usually about 26 inches.

I used the felpro 1200 to seal the intake and took the old splash pan shield and cut the intake port section off of it with tin snips. It has 4 little indentions that catch under the head to keep it from moving up when istalled. These intentation tabs keep it held in place fine. That way you...