16 Pos Max Effort R dual timing & 72 lb injectors 400.00

Welcome!

By registering with us, you'll be able to discuss, share and private message with other members of our community.

SignUp Now!

BobbyBuick

Well-Known Member
Joined
May 24, 2001
Messages
2,209
Delivered
went 10.30 @130 on stock lower end with ported heads and p trim 70
Dayton Ohio
 
I'm interested would like to know a little more about it I remember some about from a few years back and additional info would help a lot
 
It is mafless 16 position.Wot adjustment in 4% increments.many parameters can be adjusted similar to the SD chip by Eric Marshall.cold start ,park neutal leaner,idle,x-factor time and amount ,MAP gain,0-1900 RPM,1900-4000RPM,spool up leaner,mph ignore knock,dual timing,lean cruise not sure what else without getting the book out it runs closed loop .Defaults are very close
 
Any way you could supply the parameters you had set on the 10.30 pass possibly written down ? And how do you except payment?
 
Yea i never changed it much .every car is differant but i have the file still im sure.injectors are fine you dont need to do anything to them. works flawless ask anyone who knows me how well this worked.I ran this set up for over 6 years and still am running the same setup currently with 95 lb injectors.just grew out of the 72s
 
i can do paypal but email me your address and let me get the stuff out and boxed up .it wont happen until saturday is that cool.i have them in the trailer i think sorry been working on another project I can probably mail priority on saturday
bobbybuick@sbcglobal.net
 
No problem no hurry my engine and tranny are out anyway was needing to reseal everything and check it all out and wanted to go SD tired of mafs and didn't have the coin or tuning skills for xfi
 
Back
Top