3 bar map vacuum tee source

[434nova]

I am installing a 3 bar map my question is where can I tee off from for vaccum ? I was wondering if it was a good idea to tee off from the boost controller inside the car I have a knob style like the rjc controller. Or if I can tee off of the factory 2 bar map sensor the easiest would be the boost controller since its inside the car but want to make sure these are good sources for vaccum teeing. Thanks

Posted from the TurboBuick.Com mobile app

 

[earlbrown]

Why not just put in it place of the factory 2bar MAP?

 

[pacecarta]

d

 

[434nova]

I am running a fast system I will just tap of the vaccum from the 2 bar map then. What size hose should I run for the map sensor

Posted from the TurboBuick.Com mobile app

 

[Hartline Perf.]

DON'T "T" INTO ANYTHING! RUN A DEDICATED LINE TO THE SENSOR and make sure it is wire tied on each end so it can never come off.

 

[434nova]

Cal is it ok if I call you tomorrow to calibrate the sensors in the fast.

Posted from the TurboBuick.Com mobile app

 

[Hartline Perf.]

That will be fine. They should all be calibrated. The only thing that might be slightly off is the TPS. I set it up at 0.42@idle & 4.70@WOT

 

[434nova]

Thanks Cal

Posted from the TurboBuick.Com mobile app