Accel DFI Computer includes harness adapter and injectors $240 shipped

Welcome!

By registering with us, you'll be able to discuss, share and private message with other members of our community.

SignUp Now!

trick86

Solid Member
Joined
Nov 9, 2009
Messages
315
Accel Electronic Control Module, Spark/Fuel Management DFI system with adapter harness and fuel injectors (believed to be 28 lb'ers). This system was originally purchased from Duttweiler, all just recently removed from running car that is being converted back to a factory ECM setup. $240 shipped DSC02083.jpgDSC02084.jpgDSC02085.jpgDSC02086.jpg
 
thats a decent deal,

what part number are the injectors?

That unit takes a special communication cable, do you have it?

B
(I'm not interested, but I had one years ago and can answer questions)
 
thats a decent deal,

what part number are the injectors?

That unit takes a special communication cable, do you have it?

B
(I'm not interested, but I had one years ago and can answer questions)


Honestly I can't tell you much, don't have any other cables, what you see is what you get. Do have some paper work from Duttweiler with instructions of mods needed to be completed under the hood to factory wiring to make this work ie- make a few taps, remove maf connector and tie in a map sensor.

Here's the injector numbers:
060
070
0280150803
 
those injectors are 38 lb/hr, they're decent, I still have a set here somewhere.

Bob
 
If it could be used to run my edelbrock multipoint on my 1992 7.4 Dually in lieu of my factory ECM I may be interested, tired of burning up ECM's/injector drivers and still not having optimum tune. I am looking at a FAST system, currently, I have harness, injectors and MAP, no MAS, this is SD.
 
Back
Top