Alky installation help

[Brad_H]

So I herd the turbo adapter or the intake is where you install nozzle but i can't find any pics, I click on the links and it just puts me at the first page of hot air forum page. What's bad about installing it in the adapter, like problems? Just seen some post the go both ways

Ps. Post pics on this thread please......I have the smc kit

 

[notacarlo]

Right in the left. Right, or center of the up pipe just about 2" from the throttle body is good. I put my first one ( with smc 2nd gen) in the underside middle and found that it caused a small stream of liquid alchohol to concentrate on the lower half of the pipe. The newer stuff from Julio won't do that. I don't think it caused a problem, but just the bottom of the pipe being clean from oil and what not meant to me that the atomization wasn't happening correctly as intended.

Posted from the TurboBuick.Com mobile app

 

[Jerryl]

http://www.turbobuick.com/forums/index.php?threads/204243/

 

[Boost231]

http://www.turbobuick.com/forums/index.php?threads/294894/

Look at my pics. I think this is the best way

Posted from the TurboBuick.Com mobile app

 

[Brad_H]

Right in the left. Right, or center of the up pipe just about 2" from the throttle body is good. I put my first one ( with smc 2nd gen) in the underside middle and found that it caused a small stream of liquid alchohol to concentrate on the lower half of the pipe. The newer stuff from Julio won't do that. I don't think it caused a problem, but just the bottom of the pipe being clean from oil and what not meant to me that the atomization wasn't happening correctly as intended.

Posted from the TurboBuick.Com mobile app

Fail.... herd that spot is for intercooled models

 

[notacarlo]

Sorry, didn't notice this was the hot air section.

Posted from the TurboBuick.Com mobile app

 

[Brad_H]

Thanks peeps