Anyone using an M10 as a single nozzle?

[87gn-newbee]

Just wondering if anyone is running a single M10 nozzle if so any problems and what turn on point and pump speed? Thanks
Dan

 

[salvageV6]

My GN has one.

Turn on about 11psi. and pump speed max.

Reds chip with 28* timing according to direct scan, sold to me as a 100 chip. Not so sure.

Part throttle KR at times but not much WOT KR at 19-20 psi. boost.

 

[suburban]

I'm also using a single m10 with turn on at 15 lbs and pump at 8. with a lubrant 23* chip and 24lbs boost. 0 kr

 

[Crazi]

I was using a M15 in my custom kit but couldn't get rid of the stumble when it turned on and had the turn on as hi as it would go with my hobbs switch. Switched to the M10 and it runs fine now.