Bottom end clearances list

[stagemonster]

Iam getting ready to get my motor back together and my machine shopasked me what i want my clearances at. They have done buick motors before but because what i went through with the last build they told me to get them the info. I need the main bearing to crank, rod to crank, rod side to side clearance, thrust clearance, and crank endplay. This motor will be making between 600 and 700hp depending on tune used. Any help is greatly appreciated. Thanks

 

[ericttype]

i have a stroker motor and run it hard .002 on the rods .0025 on than mains thrust was .004

 

[stagemonster]

What about rod side clearance and end play?

 

[regalracer1987]

i ran .002 main and rods crank thrust was at .003 and rod side clearance should be between .015 to .003 i would call summit and get some king bearings ther really good put mine thru alot and they still look like new. did you take it to pittsburgh crank like i said ? them guys are great down there