You can type here any text you want

Bunch of parts, Autometer, etc

Welcome!

By registering with us, you'll be able to discuss, share and private message with other members of our community.

SignUp Now!

FastRegalWE2

Wish I had another Buick!
Joined
Jan 10, 2004
Messages
1,886
These are most of the parts I was going to keep for my next GN but I dont think Im going to go as far with the next one as I did with the last one...

1 50lb injector.....$25 (only have 1)
2 83 lb injectors $30 each (have 2)
5" Monster tach with shift light, Sport Comp $125
2 5/8" ELECTRIC Fuel pressure gauge with sensor and wiring $150 (was over $200 new) Sport Comp (mounted in radio surround trim with delete plate)
2 5/8" EGT with pyrometer, probe and wiring $125 Pro Comp (mounted in radio surround trim with delete plate)
2" Electric trans temp with all hardware, NEW never installed $30 Sport Comp
3" Electric Water temp with all hardware $20 Sport Comp
Cometic HG's NEW $150
Hood shocks cylinders (Kirbans) $25 for the pair
ATR driveshaft loop $50
Chrome A/C Compressor cover (BuickGN.com) $20
Manual boost controll, locking style with under dash panel and vac lines $25
stock battery hold down $10
stock 200R4 detent $20
TPS tap harness for powering FAST system (Caspers) $30
2 gauge console gauge holder, grey, $15
2 pod a-pillar gauge holder grey $20
stock coil bracket $25
stock 3 leg alt bracket $25
Serial to USB adapter cable for FAST $10
push in vavle cover breather $5
rear upper axle housing bushings, black urethane NEW $15
stock fuel return line bolts to timing cover, I had the rubber removed and repalced with braided stainless, nice piece.... $40
Power Master mini starter $150, I installed it to adjust the spacing but never fired the motor with it (was about $200)
-8 AN fuel feed line, enough to run from the tank to the fuel rail with high pressure high flow anodized mesh filter (filter alone was almost $100) Worked fine on my car with 554RWHP -$75
stock injector harness $35

All parts are off and ready, pics upon request

Or will trade entire lot for a nice low mile 87 GN.... j/k :tongue:
 
ATR driveshaft loop $50
stock battery hold down $10
2 gauge console gauge holder, grey, $15
rear upper axle housing bushings, black urethane NEW $15
need these please paypal address and shipping to 32025
 
I sent this on the other board....


Jeffery,

I'll take the fuel line, Console gauge holder, 2 guage a pilliar holder...

Let me know where to send payment and how much shipped to 08837.
 
so am I getting the console gauge holder/pod or not ?
if you compare the times on each of the post I was first
 
Ill take the stock 200-4R TV cable
 
I have a pic of it, will have to send it to you. Its held to the surround by 2 stainless screws because when I put the gauges in it kinda distorted. You wanting just the delete or the gaues installed in it as well?
 
payment sent for faskets, 2 gauges and plate please please ship with other stuff I ordered earlier
 
The following parts are SOLD (asloan)

Cometics
ATR driveshaft loop
stock battery hold down
2 gauge console gauge holder, grey,
rear upper axle housing bushings, black urethane NEW
radio delete plate with F/P and EGT gauges
 
Back
Top