Cam Help

[forcfed]

Hey guys does anyone have reccomendations on a good cam for my current buildup??

Here it is....
Block punched .035 over,Champion ported iron heads,T&D roller rocker assemblies(1.65),champion ported intake,billet caps,speedpro rings,bearings,accufab 70mm tb and dog house,havent chosen injectors,chip,and cam yet....this is what i need help on.

I don't care if it is a lopey idle.....I want power.

Thanks for any help.

Doug

 

[sweetv6]

HI !

COMP CAM 212/206 from Dave Weber Weber Racing

it is a custom grind from Dave Weber

you can check on Harper`s racing site
Orlando`s setup

lunati 210 205 look near the same

it is only my opinion

hope it help you

Claude quebec city
pclaude@labrie.qc.ca
p.s. excuse my english

GN 87, 93 ATR STREET CHIP, K & N AIR FILTER AND 340 WALBRO FUEL PUMP 13.45 @ 105 17 PSI 91 OCTANE AND XYLENE

 

[forcfed]

anyone else????
need help

 

[6 beats 8]

Comp 218/218

 

[Scott231]

Smaller cams typically have smaller power bands. You need to state how fast you want to go, not just what the other parts are.

People go fast with the 206/206, but people often go faster with bigger cams with their broader power band.

Rollers have the largest power band of any cam for these cars.

 

[forcfed]

I would like to run in the 10's if possible....I heard the rollers were the way to go...any suggestions on the roller units?
Thanks

 

[sweetv6]

YOU CAN READ THIS TOO

http://www.grapeaperacing.com/GrapeApeRacing/tech/turbocams.cfm

HOPE IT HELP YOU

CLAUDE QUEBEC CITY

 

[sumnerw]

I'm going with the CompCam ductile iron 218/212 hydraulic roller

http://www.compcams.com/Technical/Catalogs/106-03/HTML/110-113.html

This is to replace a 224/224 non-roller that went flat (#3 exhaust, of course).

I'm also going to use the CompCam 853-12 hydraulic roller lifters and K-Motion K750 springs. Got the best package price from Wise Speed Shop.

Buzz White in Houston, TX (sumnerw@flash.net)

 

[d0n_3d]

Originally posted by forcfed
Hey guys does anyone have reccomendations on a good cam for my current buildup??

Here it is....
Block punched .035 over,Champion ported iron heads,T&D roller rocker assemblies(1.65),champion ported intake,billet caps,speedpro rings,bearings,accufab 70mm tb and dog house,havent chosen injectors,chip,and cam yet....this is what i need help on.

I don't care if it is a lopey idle.....I want power.

Thanks for any help.

Doug

i've never seen a block bored .035" over??? lots of guys going fast in the 10's with mild 206/206 or 212/212 cams...if i was to do a cam right now i would do a 212/212 CC roller...great cam and really mild for street use...

 

[forcfed]

The engine block I have gotten was already bored .030 over...we needed to clean up the cylinder walls so therefore we went over another.005.
I had je make me a set of custom made pistons(with 3 extra of course....just in case)to work.

Thank you for all the input and I think I am going to go with the comp cams roller setup.

BTW does anyone know who makes a nice aluminum oil pan for our cars???

Thanks
Doug