Driveshaft Sensor and XFI

[karolko]

After Reynolds, i have decided to run a driveshaft sensor on the GN.

My question is are they all the same or are there better sensors than others.

I was recommended the Edelbrock sensor due it it's cost. anyone have experience with that one on a 28 spline 9" Stronge yolk?

what is the difference between the 2 magnet and 4 magnet collars?

Thanks guys,

Adrian

 

[gnxtc2]

I'm running the 2 magnet one from Cal which I believe is from FAST. You have to know the OD of the yoke.

Billy T.
gnxtc2@aol.com

 

[Chuck Leeper]

"what is the difference between the 2 magnet and 4 magnet collars?"

Resolution?

 

[turbobitt]

My question is are they all the same or are there better sensors than others.

I was recommended the Edelbrock sensor due it it's cost. anyone have experience with that one on a 28 spline 9" Stronge yolk?

what is the difference between the 2 magnet and 4 magnet collars?

Thanks guys,

Adrian

Don't use the edelbrock sensor. I already tried and doesn't produce a strong enough signal for the EFI to read. The edelbrock sensor is an inductive type using only two wires.

The FAST sensor is a Hall effect sensor and requires a 5V power source in addition to the two sensor wires. The Hall effect sensor seems to work much better because of this.



Allan G.

 

[HelloBozos]

Hey!!! i want one those!! They have one for Currie 9" bolt in unit?

Enjoy!