How do I add a wideband?

[DOUGGN]

What is required to add a wideband to my setup and is there any that are preferred for the Buick V6 specifically?

 

[blackgn1]

02 sensor in the exhaust stream. I like the AEM.

 

[DOUGGN]

02 sensor in the exhaust stream. I like the AEM.

Do you replace the o2 or add another bung for the wideband?

 

[wickedtt]

Add a bung for the wideband in the lower part of your downpipe. I use the PLX one and it works good.

 

[highboostgn]

I have an autometer, works great All you need to do is put a bung about 18" from the turbo on you dp, screw in the provided o2 sensor, route the wires through the firewall( I used where the throttle cable comes through) give it power, ground and enjoy

 

[DOUGGN]

How does it get integrated to the powelogger/scanmaster?

 

[Kurt04]

How does it get integrated to the powelogger/scanmaster?

Through the analog input on the Powerlogger board.

I have the Innovate MTX-L, though I haven't hooked it up yet, I've heard good things about it.

 

[huntsg]

I use AEM thru the gen 2. Works great. Tune it close then use the WB correction.

 

[3.8L V-8 eater]

PLX here hooked to the PL works good!!

 

[DOUGGN]

I have an autometer, works great All you need to do is put a bung about 18" from the turbo on you dp, screw in the provided o2 sensor, route the wires through the firewall( I used where the throttle cable comes through) give it power, ground and enjoy

I was looking at an autometer 5978 digital full sweep because it matches my other existing gages in the car. Any input on whether this is a bad choice or not?

 

[DOUGGN]

Add a bung for the wideband in the lower part of your downpipe. I use the PLX one and it works good.

Saw that a couple people have the PLX - is that the brand name or model? Who sells them?