Hi,
I have an new AC Delco IAC valve for replacing the old one in GN ´87.
I would ask, what is the correct length for the pintle measured from the IAC gasket surface to the pintle tip before installing the new IAC without destroying the new IAC ?
Or measured from the IAC thread end surface where the pintle goes in to the pintle tip?
And, how to drive correctly the pintle a little bit inwards, if the pintle is too much out?
Thanks!
I have an new AC Delco IAC valve for replacing the old one in GN ´87.
I would ask, what is the correct length for the pintle measured from the IAC gasket surface to the pintle tip before installing the new IAC without destroying the new IAC ?
Or measured from the IAC thread end surface where the pintle goes in to the pintle tip?
And, how to drive correctly the pintle a little bit inwards, if the pintle is too much out?
Thanks!