Looking for an easy, affordable, roller cam kit!

[Adam Connell]

IM getting ready to venture into my next round of mods.

Im looking at getting a mild set of stock heads, and I'd like to go with a mild roller cam setup.

Are there any good, worry free, affordable kits out there?

I do not want to restall my converter if possible. Im running a 10in 2400stall L/U PTC.

What do you guys think?

 

[blackgn1]

Comp 206/206. I don't think any roller cam setups are affordable if you know what I mean.:biggrin: You got to spend some green to go roller.

 

[charlief1]

You can get the cam by itself for less than $300 from what I read on fullthrottles site. If you've got a 109 block the you need to read this Adam. Simple, cheap, and effective but you do need to remove the engine to do it. Kinda long but worth the reading.

http://www.turbobuick.com/forums/en...non-roller-cam-parts-gn-motor-w-pictures.html

 

[Adam Connell]

Thanks for the heads up guys! Im looking for a setup I can rip apart and do in one weekend if possible! I know Im too picky haha!

Thanks for the help!

 

[Squid4life]

Like Charlie said, full throttles cams are a good choice:

FULL THROTTLE SPEED - Revolution X Roller Cam Kit Comp Lifters - Kit Configuration Page

Your sig doesn't say whether you have a higher stall converter or not, but read about the cams and it mentions what converter those cams are "matched" to or suggested with.

 

[Adam Connell]

Running a 2400 10in L/U ptc unit.

Still investigating my options! Thanks for the comments!

 

[ryan319]

check the classifieds for used parts. used lifters can save you a few hundred.