M&A Heads

[Alky V6]

Donnie, did you run into any of the problems that Brent had with his heads, or any other problems.

All except the gasket problem. My early set used the 2 long retaining screws through the center of the valve cover. I use regular 3.8L cork gaskets available from any parts store. I do have to notch them in the area of the pushrods for clearance.

 

[tta1240]

valve cover gaskets

if you need part number for valve cover gasket you can get them from ta performance.part#v1702-231-m&a.this is a rubber gasket.