More parts that need to go! Some NOS!

Under the Engine Bay
#28 Factory Air Filter Box 30.00, does this include the top , bottom and plastic snorkel ?
 
Hi,

I will take

Engine bay
24. Stock Fuel Pressure Regulator Vaccum hoses (2) $5 each - I will take 2.


Transmission
8. Trans Mount (used, 1 year old) $5

Thank you.
 
SENSORS, SWITCHES, SOLENOIDS, ELECTRICAL:
1. Quad Air Fuel Enhancer (old school!) $20
2. Dimmer switches (4, known good) $5 each
3. Headlight Switches (3, known good) $8 each
4.Tru Tech US105T Ignition Switch for column (used to test) $5
5. Relays $2 each
6. AC Pressure Switches, used $3 each
7. EGR solenoids (4, known good) $10 each
8. Antenna relays $5 each
9. Vapor Canister Solenoid (2, known good) $5
10. Chime Box (6 pin) $12
11.
12. Cam sensor with cap (known good) $65
13. Trunk Lights (3) $5 each
14. Oil Pressure Senders (4) $2 each
15. Coolant temp Sensors (used, known good) $5 each
16. Coolant switch (dummy light, used) $5 each
17. OE Fuel pump Resonators (used) $5 each





ENGINE, ENGINE BAY:
1. NEW High Torque Mini Starter $60
2. 5 stock rods $25 all
3. oil slingers (6) $5 each
4. Oil Filter Housings (3) $8 each
5. Used High Torque Mini Starter (almost new) $50
6. Stock Wastegate Actuators (3) $15
7. IC Brackets (either side) $20 each
8.
9. HydroBoost Line (Booster to gear box) $10
10.
11. Turbo oil feed (2) $10 each
12. Brass Oil feed adapter (4) $10 each
13. Turbo oil drain back tube $35
14. Turbo oil drain back brass fitting $10
15. Valve Cover Vent (passenger side, stock whole set up with turbo bell) $30
16. OE Radiator Caps (3) $5 each
17. Coil pack and Ignition Module $100
18. Fuel Lines (rail to frame, set) $50
19. Fuel Rail (3) $30 each
20. Stock Fuel pressure Regulator (2) $5 each
21. Tensioner Pulley (2) $8 each
22.
23. Hot Air oil fill tube $15
24. Stock Fuel Pressure Regulator Vaccum hoses (4) $5 each
25. Crank Sensor w/bracket $30
26. New lifters (flat tappet, Speed Pro, 16) $40 set
27. TRW Wrist Pins $15 set
28. Factory Air filter Box $30
29. Factory Air Intake Elbow (top of filter box) $10
30. Factory MAF tube (no leaks but has a wire slightly popped out, can be turned so not seen) $10
31. Valve Covers (stock drivers side, 3) $10 each
32. NEW Rod Bearings (Michigan 20 under) $10
33.
34.Speed Pro 10499 20 over Rings NEW $50
35. Power Steering pump $60
36. PS to Gear box line $15
37.
38. Used but good Water pumps (3) $5 each
39. High Volume Oil Pump Kit (installed but not ran, with new gaskets, complete kit) $20
40.
41. Coolant hose set (complete set, not radiator) $30
42.Coolant hardlines (nice shape) $35
43. Balancer Hub Bolt and Washer (7) $2 each
44. 1/4" Valve cover spacers $20
45. Valley pan baffle (custom made piece, very nice when using Felpro 1200's!) $35
46. Timing Chain (aftermarket, stock style) $10
47. Crank Sensor Bracket $6
48. Turbo Sheild (rear, the small one) $8
49. Heater Control Valves (2, used) $10 each
50. N/A Balancer (no reluctor ring) $8
51.
52. MAF Mounting Bracket (aftermarket, for use without the stock air box) $15
53. AC Evaporater Bushings (uppers and lowers) $3 each
54. Headers w/crossover (welded) $125 set
55. Oil Fill Cap (OE, 86-87) $15





INJECTORS:
1. 40# Green tops with ATR chip (used, known good) $100
2. Stock low mile Injectors with stock chip $50
3. 60# Precision Injectors set (in case) $225





TRANSMISSION:
1. Shift cable bracket (retainer) mounts on trans with pan bolts $20
2. 200r4 shift cable lever (floor shift, bracket that the cable moves on trans) $40
3. TH350 shift cable $15
4. Trans to Engine block bolts $5 set
5.
6. Speedo gear and housing (3.42) $20
7.
8.
9.
10. Mounting Clip (for wire harness to attach to trans) $5





BRAKES:
1. Baer Brakes (NEW, Rear, Ford 9", IronSport) $450
2. HydroBoost Line (booster to gear box) $10
3. Brake line (Master to prop valve) $5
4. Stock Proportioning Valve $10






OTHER, BODY, INTERIOR, CHASSIS:
1. Chrome Wipers $30 set
2. Rear Carpet inserts (grey, 87 T) $10
3. Seat belt bolt caps (grey, cover the hole for the seatbelt bolts) $5 each
4. Chrome Windsheild Trim (two sides, no top) $10 each
5. ECM box/kick panel (grey, cut for powerlogger) $10
6. Swaybar bushings (NEW, Energy Suspension 9.5108G) $15
7. Front Brake dust shields $20 set of both sides
8.
9. Coil Spring Isolators (rear) $5 each
10. Antenna Nut and Spacer (2 sets) $10 each
11. Seat Belt Release Actuators (5) $10 each
12. Dash Surrounds (Grey 85-87, Blue) $20 each
13.
14. Trunk Filler (piece between trunk and rear window) $20
15. Grille Springs (2) $15 set
16. Turbo Hood Ornament (NICE) $65
17. Rear Impact strip (not perfect but pretty nice shape) $25
18. Underdash Cover (Pass side) $10 each (will trade for a drivers side one)
19. Grey Pull Straps (2) $10 each
20. 84 T Type Center Caps (3) $8 each
21. Bumper Support Mounts (dogbones with the studs to mount to bumper shocks, plastic) $10 pair
22. Vent (for under the column, vent only) $5
23.
24. OE Lug Nuts (86-87 GN, 11) $10 all






REAR END PARTS:
1. 8.5 4:56 Richmond Gear Set $100




I can make an almost complete rebuild kit for much less than the cost of buying through the stores if someone is interested. It's going to depend on what exactly you need of course.
1. gaskets (almost every gasket except head gaskets
2. 10 under main bearings, 20 under rod bearings
3. T chain (TA stock style)
4. new lifters
5. rear main seal
6. ARP head studs
7. new molly rings (20 and 30 over)




NOS, NEW, ETC

1. ACDelco 25526984 Fan Relay (Discontinued) (have 3) $30 each
2. ACDelco 15-8229Fan Delay Relay (Discontinued) $50
3.ACDelco 22101636 Pulse Assembly $25
4. ACDelco 25055458 Fuel Strainer $4
5. ACDelco 10034222 Relay $4
6. ACDelco PT308 Connector Replacement Pack $5
7. Wells SU169 Knock Sensor $30
8. Ready Aire S032 AC Cycling Switch $15
9. Bosch 12014 O2 Sensor $10
10. Standard S-580 Pigtail $5
11.
12. Denso 234-1001 O2 Sensor $15
13. Caspers Cam Tool NEW $25
14.
15. New Wastegate puck 1.30" $10
16. Wastegate solenoid (off 8k mile car, very nice) $30
17. Cam Sensor (New) no cap or with used cap $125 no cap $135 with low mile cap
Think I could be a shipped price on the new ministarter and the cam tool to 19067? Thank you

Jim
 
I should have contacted everyone via PM's.


Mike I do believe I have a spare stashed away. Ill check tomorrow and let you know. Thanks. Jeremy
 
Could you send me a pic of the seat belt release actuators? Thanks.


Posted from the TurboBuick.Com mobile app
 
Possibly interested in Engine Bay #21, Tensioner pulley's. Are they new, shape of bearing? Pic of both? Might just get them both.
 
Do you still have the front window chrome trim ?( two pieces ). How is the condition ?

Thanls
 
Top