new pre bent trans lines

[oldbetty]

how do you get pre bent trans lines in. what has to come apart to do this...any help would be great

 

[Nick Micale]

Doing this on a lift is a great help!

I replaced a tranny line last week and just had to drop the starter, but did not remove the cable/wires.

 

[Pronto]

It's not as easy as it looks, that's for sure.

 

[bison]

Removing the crossover and possibly letting the starter hang will make it easier. I did a pair last week while I had the oil pan and timing cover off and it took about 10 minutes total. The ones I used were from inline tune and they fit almost 100% exactly as the factory lines did.


Sent from my iPhone using Tapatalk

 

[LEGACY_GN]

Check these out if you run an aftermarket transmission cooler. So much better than the pre bent hard lines. https://bowlertransmissions.com/p/112/gm-braided-cooler-line-kit