696
Active Member
- Joined
- Jun 11, 2009
I have a Autometer electronic speedometer installed and I'm using the Casper dead end with a VSS converter. I tapped my signal into the brown ECM wire in the stock VSS assembly to send it to the ECM. I went out for a test drive and have do not have a code 24 but the scanmaster and Powerlogger show 0 mph? When I had the stock dash in it worked fine. The only error I made was during a prior hook up I but the output signal from the VSS converter to the 12 volt positive feed from the stock VSS instead of the brown ECM wire. Could that have damaged something?