OK wiring experts...do I have a bad fuse box wire?

[d0n_3d]

Here's the problem. I'm trying to get my lights to work on my boost gauge on the pillar and my hood mounted fuel pressure gauge. They all of a sudden stopped working when I put in the GNX dash. All 6 gauges on the dash work flawlessly and the lights come on when they are supposed to.

I checked the fuse box and checked my fuses. They all looked good to me. So I checked the grounds on both gauges. They are fine. I checked the power wires going into the IGN fuse slots. Well when I plug those wires into the BAT slot, the lights work. But when I put them in the IGN slot with the key on...they don't work. Should I check my wires by the starter to make sure one of those lines isn't bad? Aren't one of those lines for the fuse box?

My last annoying problem I have is...whenever I turn my parking lights on or my regular lights on...I hear a constant beeping (like the fasten seatbelt beep). But I have my belt fastened and it still continually beeps. How do I stop the beep!

 

[phillyturbosix]

hmmm well not sure on the issue with the lights on the gauges. Possible fuseable link down by the starter took a hit and died.

As far as the seatbelt beeping it's the chime box under the dash is bad. Search around on the boards I know I had a few posts on it. It's about the size of a pack of smokes just to the left of the radio (looking at the dash) somewhere behind about or above where the right hand mirror adjust would be. It's a little tricky getting it out of there. My car would chime and the seat belt light would come on when I hit bumps. And out of no where. I replaced that chime box and it's been perfect. Good luck let us know how you make out!

 

[salvageV6]

IGN 3 is on the A/C fuse.

IGN 1 are all on the STBLT fuse/ACC fuse which most likely is blown due to the nature of the other problem.