Long story short. I am installing some c clip eliminators on my brother in laws 86 gn. I get everything apart. Line up the diagram that they gave me, and drilled the holes. At this point, i tried lining up the bearing with the housing before pressing it on the axle. The bearing was hitting the top of the axle tube. After some time on the phone with the supplying company, we discovered the bearing diagram was incorrect. Now the ends on my rear are drilled incorrectly. In your opinion, what should the company do to make this right. At first, they offered to send me a new end and i would have to have it welded on. They then said, they would pay to ship the rear to them after i removed it from the car. They would put a new end on it, install new eliminators, with 33 spline axles and a new spool. Only if i purchase their spool and axles for $575. I'm torn. what should i do? What should they do? I'll keep their name private for now.