You can type here any text you want

Please Help. 87 igniton module 84 coil 84 ttype

Welcome!

By registering with us, you'll be able to discuss, share and private message with other members of our community.

SignUp Now!

matt921

Member
Joined
May 26, 2014
Messages
146
I got a module for my ttype because my original one was doing some very weird stuff. I got the 87 national module and now I have no spark. Every so often it will spark. I checked my coil and it all fell under 13ohm it was
3-6 12.02
2-5 12.04
1-4 11.88

I wired the plug to what it says on gnttype I did it like this on the plug. I have gone over this so many times and nothing is wrong unless its wrong on the site.
A stayed the same
B same
C same
D - F
E - D
F - G
G - H
H - J
J - E
K- L
L - K
M - P
N - M
P- N

I have power to M N P battery I am getting power to the b wire on the camshaft sensor but its only 5V instead of 7+.

Did I do something wrong please help I need my car for work tomorrow :-(
 
I found it my green wire to my crankshaft sensor broke fixed it now it works. sorry to bother
 
actually, this thread might help someone years from now that has a similar issue..
 
well after hours of research and forum searching I found that the gnttype instruction are wrong. I found the casper instructions with a picture of the adapter an in the adapter the wiring is actually
A-A
B-B
C-C
D-E
E-J
F-D
G-F
H-G
J-H
K-L
L-K
M-N
N-P
P-M
this really upsets me cause I had to put my old module back in to see if maybe I was being dumb. That's when I found the green crank wire.
http://www.installationinstructions.com/FYI/ccciwiringinfo.pdf
 
So tried wiring it this way and still nothing. I am starting to think that maybe I should just not deal with it and just buy the harness adapter. Then ill know if the module is good or not. p.s I hate napa lol
 
OK this is seriously starting to piss me off. I got fed up with it and ordered a caspers harness I put it on got rid of the resistor wire. I got spark momentarily then nothing. I checked the voltage at the harness and I got nothing checked the voltage at the ccci fuse I have 12v. I got a brand new module from napa. I feel like I am the only one getting screwed over. this is seriously not that hard of a thing to do. If anyone can help me please do.
 
Back
Top