Powerlogger and alky-Razor

[Quiky One]

To input boost on the powerlogger, you have to tap off of the MAP green wire just like you do for the PAC alky. Since I have already tapped off it and ran it into the interor, can I just tap off that again? Will that screw with the signal? Or should I tap of of the MAP in the engine again and run a seperate wire to the logger? I dont want to risk the alky not getting full signal just for boost sensing. Running another wire wont be the end of the world.

Thanks Jason

 

[Razor]

You can tap into inside the car. Wire is wire. the signal will be the same.

HTH

 

[TurboBob]

What he said ^^^^




Bob

 

[Quiky One]

You can tap into inside the car. Wire is wire. the signal will be the same.

HTH

Ok thanks. I just didnt want the signal to be "weak". I was afraid that tapping into the wire that is tapped off the orginal wire might be bad.

Thanks guys

 

[Razor]

You can tap into inside the car. Wire is wire. the signal will be the same.

HTH

What he said ^^^^




Bob

Yup.. Jason needs to read things a few times for it to sink in