TCC prob...beating a dead horse

[87NAT]

I hate to start another TCC thread but my 9/11 isnt locking up. I did my homework on the boards before posting this.

Here is my troubleshooting list that I have done.(Tranny and converter have only 1500 miles) I have TCC lockup switch on ashtray-ground to "F" terminal

1. key on-I have 12v to purple wire on tranny from brake switch.
2. I have ground to tan/blk wire on tranny from ashtray switch.
3. key on-brake switch functions properly-no foot on brake+12v...foot on brake-no 12v
4.sol on tranny ohms out to 23 between A and D

I tried flipping switch at 20 mph second gear...nothing.
I tried pressing brake with steady throttle at cruise...nothing.
:frown: :frown: :frown:


What am I missing?

 

[mikestertwo]

Ground is terminal "A" not "F"

 

[87NAT]

Gramatical error I meant "A".

I do have my lockup switch spliced into the top left port on the ECM diagnostic plug. It has locked up in the past.

 

[TURBOTWIN2]

Maybe go back and re-check the integrity of any connections/splices you made on your setup. A simple bad connection could be your culprit. HTH.