cronanzone
Member
- Joined
- May 7, 2018
- Messages
- 72
Any ideas on this noise? It is a single disk circle D 9” pro billet.
Mainly audible @ idle/neutral. Goes away under load ( Or at least reduces greatly under load )
I know I’m probably going to have to pull it, I’m just curious if anyone out there has been down this road and had this noise and can tell me what it was for them.....And maybe its not as bad as it sounds?
It is NOT the flywheel (no cracks), or torque converter bolts (tight).
If I end up having to pull it, Recommendations for an upgrade given my setup below, street only use only.
-PT intercooler
-PT6765JB turbo
-80# inj
-Stage 3 2004r by Mike Kurtz (hoping trans not compromised that due to converter issue - trans not showing any issues, yet..)
-circle d 245mm pro billet single disk lock up 3400 stall
-340stealth FP w hot wire
-alky inj. kit
-6.1 turbo tweak chip 93 pump gas
-power logger etc.
-gen1 translator
-dual 3” GN1 exhaust
TIA!
Sent from my iPhone using Tapatalk
Mainly audible @ idle/neutral. Goes away under load ( Or at least reduces greatly under load )
I know I’m probably going to have to pull it, I’m just curious if anyone out there has been down this road and had this noise and can tell me what it was for them.....And maybe its not as bad as it sounds?
It is NOT the flywheel (no cracks), or torque converter bolts (tight).
If I end up having to pull it, Recommendations for an upgrade given my setup below, street only use only.
-PT intercooler
-PT6765JB turbo
-80# inj
-Stage 3 2004r by Mike Kurtz (hoping trans not compromised that due to converter issue - trans not showing any issues, yet..)
-circle d 245mm pro billet single disk lock up 3400 stall
-340stealth FP w hot wire
-alky inj. kit
-6.1 turbo tweak chip 93 pump gas
-power logger etc.
-gen1 translator
-dual 3” GN1 exhaust
TIA!
Sent from my iPhone using Tapatalk