Trans shield that fit a T-400

[XXQUICK6XX]

Trans shield that fit a T-400 in a GN with out major floor pounding. The one on my trans I can't even get close to bolting to the motor while it is leaning back.It's holding up my getting going on my car.Any one have any luck with any certain brand?

Steve

 

[XXQUICK6XX]

Really don't want to use a trans blanket if I don't have too.

Steve Pitts

 

[tsm3089]

I think mine is a b&m It is tight but it fits. I would avoid a blanket.

 

[Chuck Leeper]

Use the CSR hard blanket..

http://www.csr-performance.com/shop/product.da/csr831-super-shield---chevrolet-powerglide
The 1 I used fit like a glove, and didn't require working on the floor.

 

[tom j]

Have you considered a nogular SFI bell housing

 

[XXQUICK6XX]

I have a JW ultra bell put on it but the shield that was put on is just too big a gap without a lot of tunnel work. NHRA required.

Steve

 

[Underboost]

Use the CSR hard blanket..

Super Shield - Chevrolet Powerglide - Flexplate Shields - CSR
The 1 I used fit like a glove, and didn't require working on the floor.

I use this one with no problems.

 

[RYAN GRAVES]

Whats wrong with the blanket???

 

[XXQUICK6XX]

Might want to street drive the car and they retain heat where the shield has a little gap.